Welcome to Advanced FPGA-based Controllers for Power Electronic and Drive Applications

Description:

Digital controllers are now extremely powerful. With the current Field Programmable Gate Array (FPGA), designing a controller is no longer limited to the programming of a microprocessor but includes also the programming of the architecture of the processor itself along with its peripherals and its computing accelerators. As a consequence, the control designer should be now a system architect who also needs a deep understanding of the final system to be controlled. Along this line, this course aims to propose a rational use of current FPGA-based reconfigurable platforms for controlling power electronic and drive applications.
The following topics are covered in the course:
1st day (optional for students who have already worked with FPGAs): - Introduction, presentation of the current trends in terms of digital control implementation for electrical systems.
- Description of FPGA components (Internal architecture of FPGAs, recent System-on-Chip extension, presentation of the corresponding development tools), VHDL reminders.
- Hands-on basic examples, tutorial on a current FPGA development tool chain.
2nd & 3rd days: - Main design rules of an FPGA-based controller: Control algorithm refinement (design of a time continuous controller, internal delay issues, digital re-design, sampling issues, quantization issues). Architecture refinement (algorithm / architecture matching, IP-modules reusability, Hardware-In-the-Loop (HIL) validation, system-on-chip extension, High Level Synthesis (HLS) design approach).
- Presentation of practical cases: Current control of a synchronous motor drive, sensorless control techniques (Kalman filtering, high frequency injection), Adaptive MPPT for PV applications, Fault tolerant control of Voltage Source Rectifier.
- Hands-on the FPGA-based control of a power converter connected to the grid. Design of different types of regulators (PI current controller, PR current controller, sliding mode current controller, predictive current controller) and their corresponding Simulink-based and HLS-based IP modules. HiL validation.

Prerequisites: Matlab/Simulink knowledge and C/C++basic knowledge is recommended for the exercises

Form of evaluation:. The participants will be grouped and asked to team work on several case study scenarios and tasks proposed along the course. The assessment in this course will be done through a final multi-choice test in combination with delivery of exercises reports


Organizer: Professor Josep M. Guerrero, Associate Professor, Juan C. Vasquez

Lecturers: Professor Eric Monmasson, University of Cergy-Pontoise, Assistant Professor Mattia Ricco (AAU).

ECTS: 3

Time: April 24 -26, 2018

Place: 

City: 

Number of seats: 20

Deadline: April 3 2018

Important information concerning PhD courses
 We have over some time experienced problems with no-show for both project and general courses. It has now reached a point where we are forced to take action. Therefore, the Doctoral School has decided to introduce a no-show fee of DKK 5,000 for each course where the student does not show up. Cancellations are accepted no later than 2 weeks before start of the course. Registered illness is of course an acceptable reason for not showing up on those days. Furthermore, all courses open for registration approximately three months before start. This can hopefully also provide new students a chance to register for courses during the year. We look forward to your registrations.